I needed a replacement for the Citroen Berlingo Electrique E500 because the next step for that van would be to redesign the Traction Motor Speed controller and Charger BMS ECU.
So I bought the 36000 mile Kangoo on ebay in 2020 and apart from replacing tyres front brake pads and trackrod ends I had no trouble at all until 102000 miles then i got an intermittent MOTOR FAULT on the dash display. This turned into BATT CHARGE IMPOSSIBLE. After some testing I found the motor used in the 2012 Kangoo ZE is the RENAULT CONTENENTAL traction motor . This variant uses a wound rotor winding rather than permanent magnets. I'm not sure what the rotor winding current should be I have no records of what it was prior to the fault. My first guess was the brushes may have worn out so I bought another motor from ebay. This had good brushes but when i looked at the brushes they wernt worn at all! The problem preventing charging turned out to be bad insulation, this turned out to be rotor winding to ground short at one end and open circuit at the other end.
So i decided to replace the whole motor rather than just the brushes. This fixed the charging fault and all was well for 1000 miles then 'BATT CHARGE IMPOSSIBLE' message reappeared .
Looking at the rotor it looks open circuit at both ends. The reason for this is the connector silicon seal had swollen preventing it seating fully. I removed the seal and the rotor winding is now 9 ohms, it was 24 ohms before fitting so something has burnt the winding . Now i suspect the PEB was at fault all along damaging the first motor and now the 2nd motor!
Next step look at the rotor current and insulation rotor to ground previously it was >3Gohms at 1kV
Using the OBD port with CANZE worked at first but after 'BATT CHARGE IMPOSSIBLE' message appearing i get nothing on OBD
Using various versions of CAN CLIP I get 1] cant read heater so CAN-CLIP reports it cant continue until that module responds!
When the traction motor was replaced the heater started working again!
No comments:
Post a Comment